Nortel Networks 1000E - Manual (Page 425)

Installing and configuring Nortel IP Phones Page 425 of 466
Communication Server 1000E Installation and Commissioning
17 Enter the Nortel IP Phone’s (virtual) TN.
The Nortel IP Phone displays the logo, the date and time, and the DN
keys.
18 Check for dial tone and the correct DN above the display.
End of Procedure
Entering Nortel IP Phone boot parameters
using full DHCP parameters
Follow Procedure 99 to enter IP Phone boot parameters using full DHCP
parameters.
Procedure 99
Entering Nortel IP Phone boot parameters using full DHCP parameters
1 Power the Nortel IP Phone.
Within four seconds, the Nortel logo appears.
2 When the Nortel logo appears on the display, you have one second to
press the four feature keys at the bottom of the display in sequence, from
left to right.
Note: If the Nortel logo times out, repeat step 1 and step 2.
3 For the following prompts:
a. Press the BKSpace (backspace) or Clear keys to change an entry.
b. Enter new values using the telephone’s keypad.
c. Press the OK key to accept your selection.
The Nortel IP Phone prompts:
DHCP? (0-No, 1-Yes): 0
4 Enter 1 to use DHCP.
The Nortel IP Phone prompts:
DHCP:0-Full, 1-Partial:0
5 Enter the 0 to use Full DHCP.
The Nortel IP Phone prompts: