Nortel Networks 1000E - Manual (Page 204)

Page 204 of 466 Installing a Signaling Server
NN43041-310 Standard 01.11 October 2008
Figure 76
Signaling Server role selection
10 Configure the Signaling Server as Leader or Follower. See Figure 76 on
page 204 .
• If there is already a Leader Signaling Server in the IP Telephony
node, enter b at the prompt to set this Signaling Server as Follower.
The Follower Signaling Server configuration screen appears
(Figure 77 on
page 205 ). Go to step 10 on page 224 .
Please select the role of this Signaling Server.
If this Signaling Server will be a Leader then its data networking
and IP Telephony parameters must be entered now. (This will pre-
configure the IP Telephony node files.)
If this Signaling Server will be a Follower then its data networking
and IP Telephony parameters must be configured through Element
Manager later.
Please enter:
-> - Set this Signaling Server as a Leader.
- Set this Signaling Server as a Follower.
- Quit.
Enter Choice>
=====================================================================
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
Note: This step will over-write all existing configuration parameters
on this Signaling Server.