Fortinet MR1 - Manual (Page 84)

84
Default Setting
None
Command Mode
Global Config
This command adds the to the protocol-based VLAN identified by .
A group may have more than one protocol associated with it. Each interface and protocol
combination can only be associated with one group. If adding a protocol to a group causes
any conflicts with interfaces currently associated with the group, this command will fail, and
the protocol will not be added to the group. The possible values for protocol are ip, arp, and
ipx.
Syntax
switchport protocol group add protocol {ip | arp | ipx}
no switchport protocol group add protocol {ip | arp | ipx}
- a VLAN Group Name (a character string of 1 to 16 characters).
ip - IP protocol.
arp - ARP protocol.
ipx - IPX protocol.
no - This command removes the <protocol> from this protocol-based VLAN group that is identified by
this <group-name>. The possible values for protocol are ip, arp, and ipx.
Default Setting
None
Command Mode
Global Config
5.2.3.17 switchport forbidden vlan
This command used to configure forbidden VLANs.