Fortinet MR1 - Manual (Page 291)

291
5.14.1.4 show queue cos-queue
This command displays the class-of-service queue configuration for the specified interface.
The slot/port parameter is optional and is only valid on platforms that support independent
per-port class of service mappings. If specified, the class-of-service queue configuration of
the interface is displayed. If omitted, the most recent global configuration settings are
displayed.
Syntax
show queue cos-queue []
< slot/port > The interface number.
Default Setting
None
Command Mode
Privileged EXEC
Display Message
Interface This displays the slot/port of the interface. If displaying the global configuration, this output line
is replaced with a Global Config indication.
Interface Shaping Rate The maximum transmission bandwidth limit for the interface as a whole. It is
independent of any per-queue maximum bandwidth value(s) in effect for the interface. This is a
configured value.
The following information is repeated for each queue on the interface.
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is platform
dependent.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the queue, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed and the queue operates using best-effort.
This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict priority or a
weighted scheme. This is a configured value.
Queue Mgmt Type The queue depth management technique used for this queue, either tail drop or
weighted random early discard (WRED). This is a configured value.