Fortinet MR1 - Manual (Page 562)

562
ƒ OSPF Type-2
ƒ RIP
ƒ BGP4
Next Hop Slot/Port - The outgoing router interface to use when forwarding traffic to the destination.
Next Hop IP Address - The outgoing router IP address to use when forwarding traffic to the next router
(if any) in the path towards the destination. The next router will always be one of the adjacent neighbors
or the IP address of the local interface for a directly attached network.
Total Number of Routes - The total number of routes in the route table.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the switch.
Configuring Router Static Route Entry
Selection Criteria
Network Address - Specifies the IP route prefix for the destination. In order to create a route a valid
routing interface must exist and the next hop IP Address must be on the same network as the routing
interface. Routing interfaces are created on the IP Interface Configuration page. Valid next hop IP
Addresses can be viewed on the 'Route Table' screen.
Route Type - This field can be either default or static. If creating a default route, all that needs to be
specified is the next hop IP address, otherwise each field needs to be specified.
Non-Configurable Data
Subnet Mask - Also referred to as the subnet/network mask, this indicates the portion of the IP
interface address that identifies the attached network.
Protocol - This field tells which protocol created the specified route. The possibilities are one of the
following:
ƒ Static
ƒ Default
ƒ MPLS