Fortinet MR1 - Manual (Page 363)

363
6.6.2.8 split-horizon
This command sets the RIP split horizon mode. None mode will not use RIP split horizon
mode. Simple mode will be that a route is not advertised on the interface over which it is
learned. Poison mode will be that routes learned over this interface should be re-advertised
on the interface with a metric of infinity (16).
Syntax
split-horizon {none | simple | poison}
no split-horizon
none - This command sets without using RIP split horizon mode.
simple - This command sets to use simple split horizon mode.
poison - This command sets to use poison reverse mode.
no - This command cancel to set the RIP split horizon mode and sets none mode.
Default Setting
Simple
Command Mode
Router RIP Config
6.6.2.9 distribute-list
This command is used to specify the access list to filter routes received from the source
protocol. Source protocols have OSPF, Static, and Connected.
Syntax
distribute-list <1-199> out {ospf | static | connected}
no distribute-list <1-199> out {ospf | static | connected}
<1 - 199> - Access List ID value. The Access List filters the routes to be redistributed by the source
protocol.
no - This command is used to cancel the access list to filter routes received from the source protocol.
Default Setting