Fortinet MR1 - Manual (Page 417)

417
no - This command is used to reset the Threshold rate for the RP router to switch to the shortest path to
the default value.
Default Setting
50
Command Mode
Global Config
7.5.2.4 ip pimsm spt-threshold
This command is used to configure the Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobytes per second. The possible values are 0 to
2000.
Syntax
ip pimsm spt-threshold <0 - 2000>
no ip pimsm spt-threshold
<0 - 2000> - This is time interval in seconds.
no - This command is used to reset the Threshold rate for the last-hop router to switch to the shortest
path to the default value.
Default Setting
50
Command Mode
Global Config
7.5.2.5 ip pimsm staticrp
This command is used to create RP IP address for the PIM-SM router. The parameter
is the IP address of the RP. The parameter is the group
address supported by the RP. The parameter is the group mask for the group
address.
Syntax