Fortinet MR1 - Manual (Page 398)

398
This command displays all the static routes configured in the static mcast table if is specified
or displays the static route associated with the particular .
Syntax
show ip mcast mroute static []
< sourceipaddr > - the IP Address of the multicast data source.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Source IP: This field displays the IP address of the multicast packet source.
Source Mask: This field displays the mask applied to the IP address of the multicast packet source.
RPF Address: This field displays the IP address to be used as RPF for the given source and mask.
Metric: This field displays the metric value corresponding to the source address.
Interface: Valid slot and port number separated by a forward slash.
7.3.1.5 show mrinfo
This command is used to display the neighbor information of a multicast-capable router from
the results buffer pool of the router subsequent to the execution/completion of a "mrinfo
[ipaddr]" command. The results subsequent to the completion of the latest "mrinfo" will be
available in the buffer pool after a maximum duration of two minutes after the completion of
the ‘show mrinfo’ command. A subsequent issue ‘mrinfo’ will overwrite the contents of the
buffer pool with fresh results.
Syntax
show mrinfo
Default Setting
None