Fortinet MR1 - Manual (Page 600)

600
on a per-class instance basis, and it is these attributes that are applied when a match occurs.
The configuration process begins with defining one or more match criteria for a class. Then
one or more classes are added to a policy. Policies are then added to interfaces.
Packet processing begins by testing the match criteria for a packet. The 'all' class type option
defines that each match criteria within a class must evaluate to true for a packet to match that
class. The 'any' class type option defines that at least one match criteria must evaluate to
true for a packet to match that class. Classes are tested in the order in which they were
added to the policy. A policy is applied to a packet when a class match within that policy is
found.
Selection Criteria
DiffServ Admin Mode - This lists the options for the mode, from which one can be selected. The default
value is 'enable'. While disabled, the DiffServ configuration is retained when saved and can be changed,
but it is not activated. When enabled, Diffserv services are activated.
Non-Configurable Data
Class table - Displays the number of configured DiffServ classes out of the total allowed on the switch.
Class Rule table - Displays the number of configured class rules out of the total allowed on the switch.
Policy table - Displays the number of configured policies out of the total allowed on the switch.
Policy Instance table - Displays the number of configured policy class instances out of the total allowed
on the switch.
Policy Attributes table - Displays the number of configured policy attributes (attached to the policy
class instances) out of the total allowed on the switch.
Service table - Displays the number of configured services (attached to the policies on specified
interfaces) out of the total allowed on the switch.
Command Buttons
Submit - Send the updated configuration to the switch. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed.
Configuring DiffServ Class Configuration Page
Selection Criteria