Fortinet MR1 - Manual (Page 271)

271
policy-map rename
- Old Policy name.
- New policy name.
Command Mode
Global Config
Policy Type In
5.12.4 Service Commands
The 'service' command set is used in DiffServ to define:
Traffic Conditioning Assign a DiffServ traffic conditioning policy (as specified by the policy
commands) to an interface in the incoming direction.
Service Provisioning Assign a DiffServ service provisioning policy (as specified by the policy
commands) to an interface in the outgoing direction
The service commands attach a defined policy to a directional interface. Only one policy may
be assigned at any one time to an interface in a particular direction. The policy type (in, out)
must match the interface direction to which it is attached.
This set of commands consists of service addition/removal.
The CLI command root is service-policy
5.12.4.1 service-policy
This command attaches a policy to an interface in a particular direction.
Syntax
service-policy in
The command can be used in the Interface Config mode to attach a policy to a specific
interface. Alternatively, the command can be used in the Global Config mode to attach this
policy to all system interfaces. The direction value is either in or out.
is the name of an existing DiffServ policy, whose type must match the
interface direction. Note that this command causes a service to create a reference to the
policy.