Fortinet MR1 - Manual (Page 344)

344
< 1-3600 > - The range of transmit delay is 1 to 3600.
- This command sets the default OSPF Transit Delay for the specified interface.
Default Setting
The default transmit delay is 1 second.
Command Mode
Interface Config
6.3.2.34 ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection.
OSPF
Database Description packets specify the size of the largest IP packet that can be sent
without
fragmentation on the interface. When a router receives a Database Description packet, it
examines the MTU advertised by the neighbor. By default, if the MTU is larger than the router
can accept, the Database Description packet is rejected and the OSPF adjacency is not
established.
Syntax
ip ospf mtu-ignore
no ip ospf mtu-ignore
- This command enables the OSPF MTU mismatch detection.
Default Setting
Enabled.
Command Mode
Interface Config