Fortinet MR1 - Manual (Page 392)

392
no - This command resets the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface to the default value. The
maximum response time interval is reset to the default time.
Default Setting
100
Command Mode
Interface Config
7.2.2.7 ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness
is the tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of
loss, the Robustness variable may be increased for the interface.
Syntax
ip igmp robustness <1-255>
no ip igmp robustness
<1-255> - The range for <1-255> is 1 to 255.
no - This command sets the robustness value to default.
Default Setting
2
Command Mode
Interface Config
7.2.2.8 ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup
Query Interval on the interface.
Syntax
ip igmp startup-query-count <1-20>
no ip igmp startup-query-count
<1-20> - The range for <1-20> is 1 to 20.