Fortinet MR1 - Manual (Page 73)

73
Command Mode
Privileged Exec
Display Message
Slot/port: Indicates by slot id and port number which port is controlled by the fields on this line. It is
possible to set the parameters for all ports by using the selectors on the top line.
Port VLAN ID: The VLAN ID that this port will assign to untagged frames or priority tagged frames received
on this port. The value must be for an existing VLAN. The factory default is 1.
Acceptable Frame Types: Specifies the types of frames that may be received on this port. The options
are 'VLAN only' and 'Admit All'. When set to 'VLAN only', untagged frames or priority tagged frames
received on this port are discarded. When set to 'Admit All', untagged frames or priority tagged frames
received on this port are accepted and assigned the value of the Port VLAN ID for this port. With either
option, VLAN tagged frames are forwarded in accordance to the 802.1Q VLAN specification.
Ingress Filtering: May be enabled or disabled. When enabled, the frame is discarded if this port is not a
member of the VLAN with which this frame is associated. In a tagged frame, the VLAN is identified by the
VLAN ID in the tag. In an untagged frame, the VLAN is the Port VLAN ID specified for the port that received
this frame. When disabled, all frames are forwarded in accordance with the 802.1Q VLAN bridge
specification. The factory default is disabled.
GVRP: May be enabled or disabled.
Default Priority: The 802.1p priority assigned to untagged packets arriving on the port.
5.2.3.5 vlan database
This command is used to enter VLAN Interface configuration mode
Syntax
vlan database
Default Setting
None
Command Mode
Global Config
5.2.3.6 vlan
This command creates a new VLAN and assigns it an ID. The ID is a valid VLAN identification
number (ID 1 is reserved for the default VLAN). VLAN range is 2-3965.
Syntax