Fortinet MR1 - Manual (Page 480)

480
Submit - Send the updated screen to the switch. Changes take effect on the switch but these changes
will not be retained across a power cycle unless a save is performed.
8.2.1.12 Defining DHCP Client
Configuring DHCP Restart Page
This command issues a BOOTP or DHCP client request for any IP interface that has been
set to BOOTP or DHCP mode via the IP address command. DHCP requires the server to
reassign the client's last address if available. If the BOOTP or DHCP server has been moved
to a different domain, the network portion of the address provided to the client will be based
on this new domain.
Command Buttons
Reset - Send the updated screen to the switch to restart the DHCP client.
Configuring DHCP Client-identifier Page
Specify the DCHP client identifier for the switch. The DCHP client identifier is used to include
a client identifier in all communications with the DHCP server. The identifier type depends on
the requirements of your DHCP server.
Non-Configurable Data
Current DHCP Identifier (Hex/Text) - Shows the current setting of DHCP identifier.
Configurable Data
DHCP Identifier - Specifies the type of DHCP Identifier.
z Default