Fortinet MR1 - Manual (Page 437)

437
the user's access to the switch from all CLI, web, and telnet sessions will be blocked until the
authentication is complete. Refer to the discussion of maximum delay in the RADIUS configuration help.
Configurable Data
Authentication List - Select the authentication login list you want to assign to the user for system login.
Command Buttons
Submit - Sends the updated screen to the switch and causes the changes to take effect on the switch.
These changes will not be retained across a power cycle unless you perform a save.
Refresh - Updates the information on the page.
8.2.1.4 Defining Forwarding Database
Configuring MAC Table aging interval time Page
Use this panel to set the Address Ageing Timeout for the forwarding database.
Configurable Data
Address Ageing Timeout (seconds) - The forwarding database contains static entries, which are
never aged out, and dynamically learned entries, which are removed if they are not updated within a
given time. You specify that time by entering a value for the Address Ageing Timeout. You may enter any
number of seconds between 10 and 1000000. IEEE 802.1D recommends a default of 300 seconds,
which is the factory default.
Command Buttons
Submit - Update the switch with the values on the screen. If you want the switch to retain the new values
across a power cycle you must perform a save.