Fortinet MR1 - Manual (Page 213)

213
5.8.3.9 dot1x re-reauthenticate
This command begins the re-authentication sequence on the specified port. This command
is only valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto'
an error will be returned.
Syntax
dot1x re-authenticate
- is the desired interface number.
Default Setting
None
Command Mode
Privileged Exec
5.8.3.10 dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port. Depending on the token used and the value (in seconds) passed;
various timeout configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place. The
reauth-period must be a value in the range 1 - 65535.
quiet-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to define periods of time in which it will not attempt to acquire a
supplicant. The quiet-period must be a value in the range 0 - 65535.
tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine
on this port to determine when to send an EAPOL EAP Request/Identity frame to the
supplicant. The quiet-period must be a value in the range 1 - 65535.
supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supp-timeout must be a value in the
range 1 - 65535.