Fortinet MR1 - Manual (Page 403)

403
no - This command deletes an administrative scope multicast boundary specified by and
for which this multicast administrative boundary is applicable. is a group IP
address and is a group IP mask.
Default Setting
None
Command Mode
Interface Config
7.3.2.5 ip multicast ttl-threshold
This command applies the given > to a routing interface. The > is
the
TTL threshold which is to be applied to the multicast Data packets which are to be forwarded
from the interface. The value for > has range from 0 to 255.
Syntax
ip multicast ttl-threshold <0 - 255>
no ip multicast ttl-threshold
< 0 - 255 > - the TTL threshold.
no - This command applies the default > to a routing interface. The > is the TTL
threshold which is to be applied to the multicast Data packets which are to be forwarded from the
interface.
Default Setting
1
Command Mode
Interface Config
7.3.2.6 mrinfo
This command is used to query the neighbor information of a multicast-capable router
specified by []. The default value is the IP address of the system at which the
command is issued. The mrinfo command can take up to 2 minutes to complete. Only one
mrinfo command may be in process at a time. The results of this command will be available
in the results bufferpool which can be displayed by using "show mrinfo".