Fortinet MR1 - Manual (Page 538)

538
ƒ Down - This is the initial state of a neighbor conversation. It indicates that there has been no recent
information received from the neighbor. On NBMA networks, Hello packets may still be sent to
"Down" neighbors, although at a reduced frequency.
ƒ Attempt - This state is only valid for neighbors attached to NBMA networks. It indicates that no
recent information has been received from the neighbor, but that a more concerted effort should be
made to contact the neighbor. This is done by sending the neighbor Hello packets at intervals of
Hello Interval.
ƒ Init - In this state, a Hello packet has recently been seen from the neighbor. However, bidirectional
communication has not yet been established with the neighbor (i.e., the router itself did not appear
in the neighbor's Hello packet). All neighbors in this state (or greater) are listed in the Hello packets
sent from the associated interface.
ƒ 2-Way - In this state, communication between the two routers is bidirectional. This has been
assured by the operation of the Hello Protocol. This is the most advanced state short of beginning
adjacency establishment. The (Backup) Designated Router is selected from the set of neighbors in
state 2-Way or greater.
ƒ Exchange Start - This is the first step in creating an adjacency between the two neighboring
routers. The goal of this step is to decide which router is the master, and to decide upon the initial
DD sequence number. Neighbor conversations in this state or greater are called adjacencies.
ƒ Exchange - In this state the router is describing its entire link state database by sending Database
Description packets to the neighbor. In this state, Link State Request Packets may also be sent
asking for the neighbor's more recent LSAs. All adjacencies in Exchange state or greater are used
by the flooding procedure. These adjacencies are fully capable of transmitting and receiving all
types of OSPF routing protocol packets.
ƒ Loading - In this state, Link State Request packets are sent to the neighbor asking for the more
recent LSAs that have been discovered (but not yet received) in the Exchange state.
ƒ Full - In this state, the neighboring routers are fully adjacent. These adjacencies will now appear in
router-LSAs and network-LSAs.
Events - The number of times this neighbor relationship has changed state, or an error has occurred.
Permanence - This variable displays the status of the entry. 'dynamic' and 'permanent' refer to how the
neighbor became known.
Hellos Suppressed - This indicates whether Hellos are being suppressed to the neighbor.
Retransmission Queue Length - The current length of the retransmission queue.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the switch.