Fortinet MR1 - Manual (Page 531)

531
LSDB Type - Select the type of Link Advertisement associated with the specified area and address
range. The default type is 'Network Summary'.
Advertisement - Select enable or disable from the pulldown menu. If you selected enable the address
range will be advertised outside the area via a Network Summary LSA. The default is enable.
Non-Configurable Data
Area ID - The OSPF area.
IP address - The IP Address of an address range for the area.
Subnet Mask - The Subnet Mask of an address range for the area.
LSDB Type - The Link Advertisement type for the address range and area.
Advertisement - The Advertisement mode for the address range and area.
Command Buttons
Create - Send the updated configuration to the switch. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed. The new address
range will be added to the display in the non-configurable data area.
Delete - Removes the specified address range from the area configuration.
View Interface Statistics
This panel displays statistics for the selected interface. The information will be displayed only
if OSPF is enabled.
Selection Criteria
Slot/Port - Select the interface for which data is to be displayed.
Non-Configurable Data
OSPF Area ID - The OSPF area to which the selected router interface belongs. An OSPF Area ID is a
32 bit integer in dotted decimal format that uniquely identifies the area to which the interface connects.