16 switchport protocol group – Fortinet MR1 User Manual
Page 82
82
This command configures the port priority assigned for untagged packets for all ports
presently plugged into the device. Any subsequent per port configuration will override this
configuration setting.
Syntax
switchport priority all <0-7>
<0-7> - The range for the priority is 0-7.
all – All interfaces
Default Setting
0
Command Mode
Global Config
5.2.3.16 switchport protocol group
This command adds the physical <slot/port> interface to the protocol-based VLAN identified
by <group-name>. A group may have more than one interface associated with it. Each
interface and protocol combination can only be associated with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the group,
this command will fail, and the interface(s) will not be added to the group.
Syntax
switchport protocol group
no switchport protocol group
no - This command removes the interface from this protocol-based VLAN group that is identified by this
<group-name>.
Default Setting
None
Command Mode
Interface Config