Intermec 6710 - Manual (Page 70)

SECTION 4
"
Configuration
4-4 6710 Access Point User’s Guide
3. Connect the other end of the communication cable to
the DIAG port on the access point. Turn the PC on.
4. After the PC boots, start the terminal emulation
program.
5. Set the terminal emulation program’s options
according to what you want to do: Access the
configuration menus, or access the ROM command
monitor.
Accessing the Configuration
Menus
1. Set the terminal emulation parameters in your
communications software. If you are configuring this
access point for the first time, set the parameters to
the access point’s default settings:
9600, 8N1, full duplex
If you have already changed the default settings, set
the parameters to those you set in FLASH mode
through the configuration menus.
2. Plug the access point into the outlet. These messages
appear:
QXS6700K
Executing file USTART29.BIN from segment
Quickly press a key to perform configuration before startup
Starting system
3. To access the configuration menus, wait until you see
the message “Quickly press a key to perform
configuration before startup.” Press any key to access
the configuration menus.
4. See “Configuring the Access Point” on page 4-12.