Intermec 6710 - Manual (Page 160)

SECTION 4
"
Configuration
4-94 6710 Access Point User’s Guide
Table 4-1 (Continued)
Configuration Guide
z = required step; Z = recommended step
Simple Network Advanced Functions
3. Additional Configuration
(Through DIAG Port, or Remotely
Using Telnet or HTTP):
Z
Set LAN ID to a nonzero value
(page 4-23).
z
Set Global Flooding parameters in
z
Secondary LANs: Set the Flood
Register values (page 4-59) in
designated bridge candidates if
Global Flooding options are set to
z
Set Global Flooding parameters in
super root candidates (page 4-28).
designated bridge candidates if
Global Flooding options are set to
Registered (page 4-30).
z
Secondary LANs and OWL/IP:
Set the Bridge Priority in all
z
Secondary LANs and OWL/IP:
Set the Bridge Priority in all
designated bridge candidates
(page 4-57).
z
Configure the radio ports:
WLIF: Security ID (page 4-60),
Node Type (page 4-61), and Channel
and Subchannel (page 4-62).
900 MHz: Mode--Channel (page
4-74).
S-UHF: Frequency (page 4-76).
Z
Enable the Proxy ARP Server if IP
wireless stations are being sup-
ported (page 4-36).
Z
Set Ethernet filters to optimize
frames forwarded to wireless
stations (page 4-43).
z
OWL/IP: Configure all super
root candidates to Originate if
Root (page 4-82), and configure
the IP Addresses Table in each
candidate (page 4-83).
the IP Addresses Table in each
candidate (page 4-83).
z
OWL/IP: Configure [TX Filter]
in super root candidates and
designated bridges (page 4-84).