Intermec 6710 - Manual (Page 188)

SECTION 5
"
Software Download
5-28 6710 Access Point User’s Guide
When the ROM command monitor is in quiet mode you
must send three or more consecutive exclamation points
( ! ) to the DIAG port during the boot sequence to invoke the
command monitor prompt (ap>).
Because the access point is in quiet mode no prompts
appear to show you when to type the exclamation points.
The easiest way to do this is to apply power to the access
point, wait until the WLINK indicator light stops flashing
for about 1 second, and then type three or more exclamation
points.
MI String
MI String allows a custom modem initialization string to be
used in the access point. When a custom modem
initialization string is entered, it overrides the default
string issued by the ROM on powerup.
During powerup, the ROM checks the EEPROM for a valid
modem initialization string (custom initialization strings
must start with the letters AT or at). If the ROM finds a
valid string in the EEPROM, it uses this string instead of
the default string in the ROM. To remove a custom modem
initialization string, issue the RMI command.
RMI
RMI removes a custom modem initialization string from the
access point EEPROM (see “MI String”). The next time the
access point is powered on, the default modem initialization
string (located in ROM) is loaded.
X
Command X exits the password submenu and returns to
the Main Menu.