Intermec 6710 - Manual (Page 50)

SECTION 3
"
Installation
3-6 6710 Access Point User’s Guide
For this PC Port Use Cable Part Number
9-pin 226-106-001 (null modem cable)
25-pin 321-355-001
Telnet
You need the following to access the configuration menus
through a Telnet session:
"
PC or workstation with an installed and configured
network interface card and a Telnet application. You
can also use a host capable of acting as a Telnet client.
"
Telnet VT emulator (TNVT) installed on the PC.
"
IP address for the access point. See Section 4 for more
information about IP addresses.
Web Browser
The access point’s configuration menus are designed for
HTML Level 2.0 or higher. You need the following to access
the configuration menus through a Web browser:
"
Graphical browser application.
"
Internet or local network connection.
"
IP address for the access point. See Section 4 for more
information about IP addresses.
Network Management Platform
To manage the system through a network management
platform, you need the platform (such as OpenView for
Windows by Hewlett-Packard) installed on a network
management station using SNMP. The station must meet
the requirements outlined in the platform’s user guide.