Vertical and ceiling mounts – Intermec 6710 User Manual

Page 53

SECTION 3

Installation

6710 Access Point User’s Guide 3-9

Vertical and Ceiling Mounts

See Figure 3-6 and the procedure following it.

" NOTE:

If mounting the access point on a hollow wall, secure the mounting

plate to a 3/4” (thick) plywood base by four 1” X 1/4” nuts, bolts, and

washers. Anchor the plywood base to two separate wall studs by

four 2” X 1/4” diameter lag screws (two lag screws in each stud).

Figure 3-6

Mounting Bracket

6.00"

1.00"

2.00"

1.00"

2.00”