Intermec 6710 - Manual (Page 182)

SECTION 5
"
Software Download
5-22 6710 Access Point User’s Guide
ROM Command Monitor
Certain functions available through the ROM command
monitor can erase your configuration information.
Intermec STRONGLY RECOMMENDS that you only use
this option when absolutely necessary (for example, to
upgrade your FLASH software or when instructed to do so,
and under the supervision or direction of qualified Intermec
personnel).
Starting the Command Monitor
You can access the ROM command monitor only through
the DIAG port. Start the command monitor by turning the
access point off, then back on. After the access point has
completed its power-up self tests, you have about 5 seconds
to open the ROM command monitor by pressing any key on
the PC keyboard. See “Creating a Local DIAG Port
Session” in Section 4 for more information on how to access
ROM mode.
" NOTE: You cannot invoke the command monitor once the access point has
started the FLASH program. If the access point enters its boot
sequence, you have to reboot the access point to open the ROM
command monitor.
When the ROM command monitor opens, the following
displays on the PC:
QXS6700K Vx.xx MMM DD YYYY
ap>
"
QXS6700K is the program name of the ROM.
"
x.xx is the version of the ROM command monitor.
"
MMM DD YYYY is the month, day, and year the
version was released.
"
ap> is the command prompt.