Intermec 6710 - Manual (Page 169)

SECTION 5
"
Software Download
6710 Access Point User’s Guide 5-9
"
As a server, the access point can service read and
write requests from an access point client. To operate
as a TFTP server, the access point must be loaded
with these software versions:
"
ROM version 1.13 or greater
"
FLASH (USTART29.BIN) version 1.23 or greater
"
As a client, the access point can read files from and
write files to any TFTP server on the network. The
client always requests octet mode.
In general, TFTP client sessions should fail only if the
server is not responding because it is busy serving other
clients or because it has not been started. In either case,
the access point back-off algorithm should prevent excessive
network traffic when many access points are trying to
contact a TFTP server. When you type TFTP client
commands at the command line, the access point does not
retry failed transfers.
" NOTE: Near the end of this section is a detailed example of how to use
TFTP to upgrade an access point with a new version of FLASH. The
example incorporates most of the TFTP commands.
TFTP Server
Use the Server command to display TFTP commands. The
format is:
File>
tftp server
These commands are supported:
Help for Server command:
Argument
Description
Start Start TFTP server
Stop Stop TFTP server
Log Display TFTP server message log
? Display this help
File>