Intermec 6710 - Manual (Page 64)

SECTION 3
"
Installation
3-20 6710 Access Point User’s Guide
Applying Power
B CAUTION: NEVER remove the cover of the access point with power
applied. ALWAYS make the access point connection before
making the connection at the source (“load to source”).
Damage to the radio or other devices can occur with the cover
removed.
" NOTE: Connect the access point to an uninterruptable power source — a
power source that cannot be inadvertently turned off or otherwise
disconnected.
Power is applied to the access point through the grounded
AC INPUT connector. See Figure 3-15 and the following
procedure.
1. Plug the receptacle end of the power cord (1) into the
AC INPUT connector.
2. Insert the three-prong plug on the other end of the
power cord (2) into a grounded power outlet.
3. See Section 6, “Indicator Lights,” for descriptions of
the indicator lights.