Intermec 6710 - Manual (Page 141)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-75
For example, in the United States the following
combinations are valid:
DS 225K-Channel 25
DS 090K-Channel 10
DS 090K-Channel 15
DS 090K-Channel 20
DS 090K-Channel 25
DS 090K-Channel 30
DS 090K-Channel 35
DS 090K-Channel 40
DS 450K-Channel 25
The following chart describes the settings shown in the
previous sample screen:
Setting Description
DS 225K--Channel 25 Uses one Direct Sequenced channel at
225,000 bits per second. This one
moderate-speed channel uses all avail-
able bandwidth. DS 225K is mode 1.
DS 090K--Channel 10
through
DS 090K--Channel 40
Use one of several Direct Sequenced
channels at 90,000 bits per second.
Seven low-speed channels share the
available bandwidth. DS 90K is mode
2.
DS 450K--Channel 25 Uses one Direct Sequenced channel at
450,000 bits per second. This one
high-speed channel uses all available
bandwidth. DS 450K is mode 3.
900 MHz radio options for a wireless station are set
through its Advanced Setup firmware menus. Wireless
station and access point settings must match. Refer to the
wireless station’s user guide for more information about
Advanced Setup.