Intermec 6710 - Manual (Page 147)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-81
Select primary and fallback super root access points
on the home subnet. IP addresses for wireless
stations used with OWL/IP must belong to the home
subnet. See OWL/IP limitations in Appendix E.
2. Select access points on each remote subnet to serve as
designated bridges for those subnets. Configure
primary and fallback bridge priorities under the
[Bridging] menu, described on page 4-57.
Configure and record the IP addresses of all
designated bridges. Designated bridge candidates
must have permanent IP addresses. (DHCP should
not be used to assign IP addresses to OWL/IP
designated bridges unless a permanent lease is
specified, and the access points are rebooted prior to
configuring OWL/IP.)
It is not necessary to configure Global Flooding or
Flood Register settings for OWL/IP designated
bridges. These do not apply to OWL/IP designated
bridges.
3. Use the [OWL/IP] menu to configure super root
candidates to Originate if Root (described on page
4-82). Configure the IP Addresses Table (page 4-83)
using the appropriate addressing for designated
bridges on each subnet. All super root candidates
should be configured identically.
4. Configure OWL/IP [TX Filter] settings in all super
root and designated bridge candidates. A discussion of
[TX Filter] starts on page 4-84.
5. For networks using IP networking on wireless
stations, use of the ARP server capability in the access
point is strongly recommended. A discussion of ARP
server starts on page 4-36.