Intermec 6710 - Manual (Page 131)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-65
Wireless Hops
To create a wireless hop, you must enable one or more
WLIF radios on the distribution LAN as wireless hopping
Masters and then configure the Slave stations (through
[Slave Parms]) to connect to these Masters.
EXAMPLE: In Figure 4-4, two access points have two WLIF radios. One radio is
configured as a Master to provide the wireless connection to the
distribution LAN. The other radio is configured as a Slave to service
wireless station traffic.
Slave
Figure 4-4
Wireless Hopping Through WLIF Radios
Ethernet (Distribution) LAN
Secondary LAN
Secondary LAN
Master
Slave
Master
Slave
Master
" NOTE: For best performance, use one or two external antenna kits when
using two WLIF radios. A minimum separation of 10 feet (3 meters)
between antennas is required.