Intermec 6710 - Manual (Page 54)

SECTION 3
"
Installation
3-10 6710 Access Point User’s Guide
1. Inspect where the access point will be mounted and
determine what hardware is needed. Different
surfaces such as drywall, wood, and concrete block
require different mounting hardware. For this reason,
a universal mounting bracket is included with the
access point.
2. Remove the mounting plate from the bottom of the
access point.
3. Using the mounting plate as a template, mark where
the anchors that secure the mounting plate to the
surface should be located.
4. Attach the access point mounting plate to the wall or
ceiling with 2I x 1/4I diameter lag screws or bolts,
depending upon the surface. The mounting plate
must be secured to the surface by at least four
anchors, one on each corner.
5. Reattach the access point to the mounting plate.
6. Make all Ethernet connections. See “Connecting to
Ethernet.”
7. Make all power connections. See “Applying Power” on
page 3-20.
8. Watch the indicator lights to verify that the access
point is working properly. See Section 6, “Indicator
Lights,” for help.
" NOTE: An optional locking kit is available. See Section 2, “Features and
Functional Overview,” for more information.
Connecting to Ethernet
The following pages show how to connect the access point to
10BASE2, 10BASE5, and 10BASE-T Ethernet.