Intermec 6710 - Manual (Page 135)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-69
Setting Description
Default
(default)
Uses the factory-set settings for the radio proto-
col (settings are located under [Manual MAC
Parms]). The Default setting should be used for
normal operation.
Interference Optimizes the settings for the radio protocol for
better performance in environments with high
interference or multipath.
Throughput Optimizes the settings for the radio protocol for
better performance of file transfer operations in
open or uncongested environments, such as of-
fice areas.
Manual Allows you to adjust WLIF MAC parameters
(located under [Manual MAC Parms]) individu-
ally. Do not select this setting unless a Systems
Engineer directs you to do so.
[Manual MAC Parms]
" NOTE: Adjusting the settings for [Manual MAC Parms] is not advised unless
instructed by Technical Support.
Occasionally, a site’s WLIF radio parameters may need to
be fine-tuned. Options for [Manual MAC Parms] enable the
Customer Response Center to fine-tune this access point’s
performance. Settings are:
Hop Period <200ms>
Beacon Frequency 2
Deferral Slot
Fairness Slot
Fragment Size 310
Transmit Mode
Norm Ack Retry 255
Frag Ack Retry 255
Norm QFSK Retry 255
Frag QFSK Retry 255