Intermec 6710 - Manual (Page 186)

SECTION 5
"
Software Download
5-26 6710 Access Point User’s Guide
FI
FI is a destructive command that erases all downloaded
files in FLASH memory.
FS s n
FS is a destructive command that redefines the default
(factory set) file segments in FLASH memory.
FB s
FB s designates which segment(s) of FLASH memory the
boot program is located in. If the access point boot program
is located in a segment other than what is designated, the
boot program will not run. See “Fb Command” on page 5-5
for more information.
FFR f
FFR f runs the specified file (f). The file specified with the
FFR command must be an executable file.
FPC f s
FPC f s copies a specified file (f) from an SRAM card
installed in PC card slot NIC2 to a specified segment (s) of
the access point FLASH.
" NOTE: The FPC f s command copies the first file of the specified file name it
finds. Attempting to load multiple files with the same file name will
result in unreachable or unreadable files.
FPD
FPD shows the file system directory of an installed SRAM
card. The card must be inserted in PC card slot NIC2 on
the access point. The FPD command will not work on a
card inserted in slot NIC1.
The following information about the PC card file system is
returned: