Intermec 6710 - Manual (Page 56)

SECTION 3
"
Installation
3-12 6710 Access Point User’s Guide
Middle of Segment
See Figure 3-8 and the procedure following it.
Figure 3-8
Middle of 10BASE2 Segment
10 BASE 2
10 BASE T
AC INPUT
100/240 VAC
AUI DIAG
1 1 2
1. 10BASE2 cable
2. T-connector
1. Plug the T-connector (2) into the 10 BASE 2 port.
2. Plug one end of the Ethernet coaxial cable (1) into an
open end of the T-connector. Align the notches in the
cable end with the posts on the T-connector, push the
cable in, and twist about one-quarter turn.
3. Plug the end of another Ethernet coaxial cable
segment into the other open end of the T-connector.