PLANET XGS3-24040 - Manual (Page 80)

Chapter 6 Cluster Configuration
6-3
cluster keepalive loss-count <int>
no cluster keepalive loss-count
Set the max number of lost
keep-alive messages that can be
tolerated in the cluster.
Admin mode
clear cluster nodes [nodes-sn
<candidate-sn-list> | mac-address
>]
Clear nodes in the list of candidate
switches maintained by the switch.
4. Configure attributes of the cluster in the candidate switch
Command Explanation
Global Mode
cluster keepalive interval <second>
no cluster keepalive interval
Set the keep-alive interval of the
cluster.
cluster keepalive loss-count <int>
no cluster keepalive loss-count
Set the max number of lost
keep-alive messages that can be
tolerated in the clusters.
5. Remote cluster network management
Command Explanation
Admin Mode
rcommand member <member-id>
In the commander switch, this
command is used to configure and
manage member switches.
rcommand commander
In the member switch, this command
is used to configure the commander
switch.
cluster reset member [id |
mac-address ]
In the commander switch, this
command is used to reset the
member switch.
cluster update member
[ascii | binary]
In the commander switch, this
command is used to remotely
upgrade the member switch. It can
only upgrade nos.img file.