PLANET XGS3-24040 - Manual (Page 405)

Chapter 44 IPv6 Multicast Protocol
44-3
Enable PIM-SM for the specific interface:
Command Explanation
Interface configuration mode
ipv6 pim dense-mode
To enable PIM-DM for the specified interface
(required).
2．Configure static multicast routing entries
Command Explanation
Global configuration mode
ipv6 mroute <X:X::X:X>
<X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure IPv6 static multicast routing entries.
The no form of this command will remove the
specified routing entry.
3. Configure additional PIM-DM parameters
（1）Configure parameters for PIM-DM interfaces
1) Configure the interval for PIM-DM hello messages
Command Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-DM hello
messages. The no form of this command will
restore the default value.
2) Configure the interval for PIM-DM state-refresh messages
Command Explanation
Interface Configuration Mode
ipv6 pim state-refresh
origination-interval
no ipv6 pim state-refresh
origination-interval
To configure the interval for sending PIM-DM
state-refresh packets. The no form of this
command will restore the default value.
3) Configure the boundary interfaces
Command Explanation
Interface Configuration Mode