PLANET XGS3-24040 - Manual (Page 72)

Chapter 4 Basic Switch Configuration
4-23
Scenario 4: Switch acts as FTP client to view file list on the FTP server.
Synchronization conditions: The switch connects to a computer by an Ethernet port, the computer is a FTP
server with an IP address of 10.1.1.1; the switch acts as a FTP client, and the IP address of the switch
management VLAN1 interface is 10.1.1.2.
 FTP Configuration
PC side:
Start the FTP server software on the PC and set the username “Switch”, and the password “Admin”.
Switch:
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 10.1.1.2 255.255.255.0
Switch(Config-if-Vlan1)#no shut
Switch(Config-if-Vlan1)#exit
Switch#copy ftp: //Switch: [email protected]
220 Serv-U FTP-Server v2.5 build 6 for WinSock ready...
331 User name okay, need password.
230 User logged in, proceed.
200 PORT Command successful.
150 Opening ASCII mode data connection for /bin/ls.
recv total = 480
nos.img
nos.rom
parsecommandline.cpp
position.doc
qmdict.zip
…(some display omitted here)
show.txt
snmp.TXT
226 Transfer complete.
4.5.3.4 FTP/TFTP Troubleshooting
4.5.3.4.1 FTP Troubleshooting
When upload/download system file with FTP protocol, the connectivity of the link must be ensured, i.e.,
use the “Ping” command to verify the connectivity between the FTP client and server before running the FTP
program. If ping fails, you will need to check for appropriate troubleshooting information to recover the link
connectivity.