PLANET XGS3-24040 User Manual
Page 42
XGS3 Configuration Guide
3-16
Step 2: Run HTTP protocol on the host.
Open the Web browser on the host and type the IP address of the switch, or run directly the HTTP protocol on
the Windows. For example, the IP address of the switch is “10.1.128.251”;
Figure 3-9 Run HTTP Protocol
When accessing a switch with IPv6 address, it is recommended to use the Firefox browser with 1.5 or later
version. For example, if the IPv6 address of the switch is 3ffe:506:1:2::3. Input the IPv6 address of the switch
is
http://[3ffe:506:1:2::3]
and the address should draw together with the square brackets.
Step 3: Login to the switch.
Login to the Web configuration interface. Valid login name and password are required, otherwise the switch
will reject HTTP access. This is a method to protect the switch from unauthorized access. As a result, when
Telnet is enabled for configuring and managing the switch, username and password for authorized Telnet
users must be configured with the following command:
username
To open the local authentication style with the following command: authentication line web login local.
Privilege option must exist and just is 15. Assume an authorized user in the switch has a username of
“admin”, and password of “admin”, the configuration procedure should like the following:
Switch>enable
Switch#config
Switch(config)#username admin privilege 15 password 0 admin
Switch(config)#authentication line web login local