PLANET XGS3-24040 - Manual (Page 301)

Chapter 38 OSPFv3
38-6
IPv6 ospf dead-interval <time>
[instance-id ]
no IPv6 ospf dead-interval
[instance-id ]
Sets the interval before regarding a neighbor
layer3 switch invalid; the “no IPv6 ospf
dead-interval [instance-id ]” command
restores the default setting.
IPv6 ospf transit-delay <time>
[instance-id ]
no IPv6 ospf transit-delay
[instance-id ]
Sets the delay time before sending link-state
broadcast; the “no IPv6 ospf transit-delay
[instance-id ]” command restores the
default setting.
IPv6 ospf retransmit <time>
[instance-id ]
no IPv6 ospf retransmit [instance-id
]
.Sets the interval for retransmission of link-state
advertisement among neighbor layer3 switches;
the “no IPv6 ospf retransmit [instance-id
]” command restores the default setting.
（2）Configure OSPFv3 route introduction parameters
Configure OSPFv3 route introduction parameters
Commands Explanation
OSPF Protocol Mode
[no]redistribute {kernel |connected|
static| rip| isis| bgp} [metric<value>]
[metric-type {1|2}][route-map]
Introduces other protocol discovery routing
and static routing regarded as external
routing message. The [no] redistribute
{kernel |connected| static| rip| isis| bgp}
[metric<value>] [metric-type
{1|2}][route-map] command
cancels imported external routing message.
（3）Configure OSPFv3 importing the routes of other OSPFv3 processes
1）Enable the function of OSPFv3 importing the routes of other OSPFv3 processes
Command Explanation
Router IPv6 OSPF Mode
redistribute ospf [<process-id>]
[metric<value>] [metric-type
{1|2}][route-map<word>]
no redistribute ospf [<process-id>]
[metric<value>] [metric-type
{1|2}][route-map<word>]
Enable or disable the function of OSPFv3
importing the routes of other OSPFv3
processes.
2）Display relative information
Command Explanation
Admin Mode or Configure Mode