PLANET XGS3-24040 - Manual (Page 412)

Chapter 44 IPv6 Multicast Protocol
44-10
（2）Configure global PIM-SM6 parameter
1) Configure the switch as a candidate BSR
Command Explanation
Global Configuration Mode
ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
no Ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
This command is the global candidate BSR
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR. The no operation is to
cancel the configuration of BSR.
2) Configure the switch as a candidate RP
Command Explanation
Global Configuration Mode
ipv6 pim rp-candiate
{vlan<vlan-id>|
loopback<index>|<ifname>}
[<group range>] [<priority>]
no ipv6 pim rp-candiate
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM candidate
RP so that it can compete for RP router with
other candidate RP. The no operation is to
cancel the configuration of RP.
3) Configure static RP
Command Explanation
Global Configuration Mode
ipv6 pim rp-address <rp-address>
[<group-range>]
no ipv6 pim rp-address
<rp-address> {all|<group-range>}
To configure the address of the candidate RP.
The no form of this command will remove the
configuration for the candidate RP.
4. Disable PIM-SM protocol
Command Explanation
Interface Configuration Mode
no ipv6 pim sparse-mode To disable the PIM-SM6 protocol.
Global Configuration Mode
no ipv6 pim sparse-mode To disable PIM-DM globally.