PLANET XGS3-24040 - Manual (Page 265)

Chapter 35 RIP
35-10
b) Layer 3 SwitchB
Configure the IP address of interface vlan 1
SwitchB#config
SwitchB(config)# interface vlan 1
SwitchB(Config-if-Vlan1)# ip address 10.1.1.2 255.255.255.0
SwitchB(Config-if-Vlan1)exit
Initiate RIP protocol and configure the RIP segments
SwitchB(config)#router rip
SwitchB(config-router)#network vlan 1
SwitchB(config-router)#exit
c) Layer 3 SwitchC
Configure the IP address of interface vlan 1
SwitchC#config
SwitchC(config)# interface vlan 1
Configure the IP address of interface vlan 1
SwitchC(Config-if-Vlan1)# ip address 20.1.1.2 255.255.255.0
SwitchC(Config-if-Vlan1)#exit
Initiate RIP protocol and configure the RIP segments
SwitchC(config)#router rip
SwitchC(config-router)#network vlan 1
SwitchC(config-router)#exit
35.3.2 Typical Examples of RIP aggregation function
The application topology as follows：
Figure 3-2 Typical application of RIP aggregation
S1
S2
vlan1:192.168.10.1
vlan1:192.168.10.2
192.168.20.0/22
192.168.21.0/24
192.168.22.0/24
192.168.23.0/24
192.168.24.0/24