PLANET XGS3-24040 - Manual (Page 174)

Chapter 21 Layer 3 Forward Configuration
21-4
Multicast addresses increased and the support for multicast has enhanced. By dealing with IPv4 broadcast
functions such as Router Discovery and Router Query, IPv6 multicast has completely replaced IPv4
broadcast in the sense of function. Multicast not only saves network bandwidth, but enhances network
efficiency as well.
21.2.2 IP Configuration
Layer 3 interface can be configured as IPv4 interface, IPv6 interface.
21.2.2.1 IPv4 Address Configuration
IPv4 address configuration task list:
1．Configure the IPv4 address of three-layer interface
1． Configure the IPv4 address of three-layer interface
Command Explanation
VLAN Interface Configuration Mode
ip address [secondary]
no ip address [ ]
Configure IP address of VLAN
interface; the no ip address
[ ] command
cancels IP address of VLAN
interface.
21.2.2.2 IPv6 Address Configuration
The configuration Task List of IPv6 is as follows:
1. IPv6 basic configuration
(1) Globally enable IPv6
(2) Configure interface IPv6 address
(3) Configure IPv6 static routing
2. IPv6 Neighbor Discovery Configuration
(1) Configure DAD neighbor solicitation message number
(2) Configure send neighbor solicitation message interval
(3) Enable and disable router advertisement
(4) Configure router lifespan
(5) Configure router advertisement minimum interval
(6) Configure router advertisement maximum interval
(7) Configure prefix advertisement parameters
(8) Configure static IPv6 neighbor entries
(9) Delete all entries in IPv6 neighbor table
(10) Set the hoplimit of sending router advertisement
(11) Set the mtu of sending router advertisement
(12) Set the reachable-time of sending router advertisement