PLANET XGS3-24040 - Manual (Page 299)

Chapter 38 OSPFv3
38-4
As a result of continuous development of IPv6 network, it has the network environment of nonsupport IPv6
sometimes, so it needs to do the IPv6 operation by tunnel. Therefore, our OSPFv3 supports configuration on
configure tunnel, and passes through nonsupport IPv6 network by unicast packet of IPv4 encapsulation.
38.2 OSPFv3 Configuration Task List
OSPFv3 Configuration Task List:
1. Enable OSPFv3 (required)
（1） Enable/disable OSPFv3(required)
（2） Configure the router-id number of the layer3 switch running OSPFv3 (optional)
（3） Configure the network scope for running OSPFv3 (optional)
（4） Enable OSPFv3 on the interface (required)
2. Configure OSPFv3 auxiliary parameters (optional)
（1） Configure OSPFv3 packet sending mechanism parameters
1) Set the OSPFv3 interface to receive only
2) Configure the cost for sending packets from the interface
3) Configure OSPFv3 packet sending timer parameter (timer of broadcast interface sending HELLO
packet to poll, timer of neighboring layer3 switch invalid timeout, timer of LSA transmission delay
and timer of LSA retransmission.
（2） Configure OSPFv3 route introduction parameters
1) Configure default parameters (default type, default tag value, default cost)
2) Configure the routes of the other protocols to introduce to OSPFv3
（3） Configure OSPFv3 importing the routes of other OSPFv3 processes
1) Enable the function of OSPFv3 importing the routes of other OSPFv3 processes
2) Display relative information
3) Debug
（4） Configure other OSPFv3 protocol parameters
1) Configure OSPFv3 routing protocol priority
2) Configure cost for OSPFv3 STUB area and default route
3) Configure OSPFv3 virtual link
4) Configure the priority of the interface when electing designated layer3 switch
3. Close OSPFv3 Protocol
1. Enable OSPFv3 Protocol
It is very simple to run the basic configurations of OSPFv3 routing protocol on the Layer 3 switch of XGS3
series switch, normally only enabling OSPFv3, implement OSPFv3 interface, the default value is defined to
OSPFv3 protocol parameters. Refer to 2. Configure OSPF auxiliary parameters, if the OSPFv3 protocol
parameters need to be modified.
Commands Explanation
Global Mode