PLANET XGS3-24040 - Manual (Page 271)

Chapter 36 RIPng
36-4
1）Configure route introduction (default route metric, configure routes of the other protocols to be introduced in
RIP)
Command Explanation
Router configuration mode
default-metric
no default-metric
Configure the default metric of distributed route;
the no default-metric command restores the
default configuration 1.
[no]redistribute {kernel |connected|
static| ospf| isis| bgp}
[metric<value>] [route-map]
Redistribute the routes distributed in other route
protocols into the RIPng data packet; the
[no]redistribute {kernel |connected| static|
ospf| isis| bgp} [metric<value>]
[route-map] command cancels the
distributed route of corresponding protocols.
[no]default-information originate
Generate a default route to the RIPng protocol;
the [no] default-information originate
command cancels the feature.
2）Configure the route offset
Command Explanation
Router configuration mode
[no] offset-list
|access-list-name> {in|out}
[]
Configure that provide a deviation value to the
route metric value when the port sends or
receives RIPng data packet; the [no] offset-list
{in|out} [] command
removes the deviation table.
3）Configure and apply route filter and route aggregation
Command Explanation
Router configuration mode
[no] distribute-list
{
|access-list-name> |
prefix} {in|out}
[]
Set to filter the route when the interface sends
and receives RIPng data packets. The [no]
distribute-list {< access-list-number
|access-list-name > |
prefix} {in|out} []
command means do not set the route filter.
[no]aggregate-address
Configure route aggregation, the [no]
aggregate-address command
cancels the route aggregation.