PLANET XGS3-24040 - Manual (Page 485)

Chapter 48 The Number Limitation Function of Port, MAC in VLAN and IP Configuration
48-3
2． Enable the number limitation function of MAC、IP in VLAN
Command Explanation
VLAN configuration mode
vlan mac-address dynamic maximum
no vlan mac-address dynamic
maximum
Enable and disable the number limitation
function of MAC in the VLAN.
Interface configuration mode
ip arp dynamic maximum
no ip arp dynamic maximum
Enable and disable the number limitation
function of ARP in the VLAN.
ipv6 nd dynamic maximum
no ipv6 nd dynamic maximum
Enable and disable the number limitation
function of NEIGHBOR in the VLAN.
3． Configure the timeout value of querying dynamic MAC.
Command Explanation
Global configuration mode
mac-address query timeout
Configure the timeout value of querying
dynamic MAC.
4． Display and debug the relative information of number limitation of MAC、IP on ports
Command Explanation
Admin mode
show mac-address dynamic count {vlan
|interface ethernet
}
Display the number of dynamic MAC in
corresponding ports and VLAN.
show arp-dynamic count {vlan
| interface ethernet
}
Display the number of dynamic ARP in
corresponding ports and VLAN.
show nd-dynamic count {vlan
| interface ethernet
}
Display the number of dynamic
NEIGHBOUR in corresponding ports and
VLAN.
debug switchport mac count
no debug switchport mac count
All kinds of debug information when
limiting the number of MAC on ports.
debug switchport arp count
no debug switchport arp count
All kinds of debug information when
limiting the number of ARP on ports.
debug switchport nd count
no debug switchport nd count
All kinds of debug information when
limiting the number of NEIGHBOUR on
ports.