PLANET XGS3-24040 - Manual (Page 261)

Chapter 35 RIP
35-6
distribute-list {< access-list-number
|access-list-name >|prefix
ame>}{in|out} []
no distribute-list {< access-list-number
|access-list-name >|prefix
ame>}{in|out} []
Configure and apply the access table and prefix
table to filter the routes. The no distribute-list
{< access-list-number
|access-list-name>|prefix}{
in|out} []command means do not use
the access table and prefix table.
5）Configure the split horizon
Command Explanation
Interface configuration mode
ip rip split-horizon [poisoned]
no ip rip split-horizon
Configure that take the split horizon when the
port sends data packets; poisoned for poison
reverse the no ip rip split-horizon command
cancels the split horizon.
（3）Configure other RIP protocol parameters
1）Configure RIP routing priority
2）Configure the RIP route capacity limit in route table
3）Configure timer for RIP update, timeout and hold-down
4）Configure RIP UDP receiving buffer size
Command Explanation
Router configuration mode
distance <number> [<A.B.C.D/M> ]
[
>]
no distance [<A.B.C.D/M> ]
Specify the route administratively distance of
RIP protocol; the no distance [<A.B.C.D/M> ]
command restore the default value 120.
maximum-prefix
[]
no maximum-prefix
no maximum-prefix
Configure the maximum of RIP route; the no
maximum-prefix
no maximum-prefix command cancels the
limit.
timers basic
no timers basic
Adjust the update, timeout and garbage
collection time, the no timers basic command
restores the default configuration.
recv-buffer-size
no recv-buffer-size
The command configures the UDP receiving
buffer size of the RIP; the no recv-buffer-size
command restores the system default values.
3. Configure RIP-I/RIP-II toggling