PLANET XGS3-24040 - Manual (Page 353)

Chapter 43 Ipv4 Multicast Protocol
43-7
4. Disable PIM-DM protocol
Command Explanation
Interface Configuration Mode
no ip pim dense-mode To disable the PIM-DM protocol for the interface.
Global Configuration Mode
no ip pim multicast-routing To disable PIM-DM globally.
43.2.3 PIM-DM Configuration Examples
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to corresponding vlan,
and enable PIM-DM Protocol on each vlan interface.
Figure 1-1 PIM-DM Typical Environment
The configuration procedure for SwitchA and SwitchB is as follows:
(1) Configure SwitchA:
Switch(config)#ip pim multicast-routing
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 10.1.1.1 255.255.255.0
Switch(Config-if-Vlan1)# ip pim dense-mode
Switch(Config-if-Vlan1)#exit
Switch(config)#interface vlan2
Switch(Config-if-Vlan2)# ip address 12.1.1.1 255.255.255.0
Switch(Config-if-Vlan2)# ip pim dense-mode
(2) Configure SwitchB:
Switch(config)#ip pim multicast-routing
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 12.1.1.2 255.255.255.0
Switch(Config-if-Vlan1)# ip pim dense-mode
Switch(Config-if-Vlan1)#exit
Switch(config)#interface vlan 2
Switch(Config-if-Vlan2)# ip address 20.1.1.1 255.255.255.0
Switch(Config-if-Vlan2)# ip pim dense-mode
SwitchA SwitchB
Vlan 2 Vlan 1 Vlan 2 Vlan 1