PLANET XGS3-24040 - Manual (Page 391)

Chapter 43 Ipv4 Multicast Protocol
43-45
ip igmp query-interval <time_val>
no ip igmp query-interval
Configure the interval of IGMP query messages
sent periodically; the “no ip igmp
query-interval” command restores default
value.
ip igmp query-max-response-time
<time_val>
no ip igmp
query-max-response-time
Configure the maximum response time of the
interface for IGMP query; the “no ip igmp
query-max-response-time” command restores
default value.
ip igmp query-timeout <time_val>
no ip igmp query-timeout
Configure the time-out of the interface for IGMP
query; the “no ip igmp query-timeout”
command restores default value.
（3）Config IGMP version
Command Explanation
Global Mode
ip igmp version <version>
no ip igmp version
Configure IGMP version on the interface; the “no
ip igmp version” command restores the default
value.
3. Disable IGMP Protocol
Command Explanation
Interface Configuration Mode
no ip dvmrp | no ip pim
dense-mode | no ip pim
sparse-mode | no ip dvmrp
multicast-routing | no ip pim
multicast-routing
Disable IGMP Protocol.
43.9.3 IGMP Configuration Examples
As shown in the following figure, add the Ethernet ports of Switch A and Switch B to corresponding VLAN, and
start PIM-DM on each VLAN interface.
Figure 1-9 IGMP Network Topology Diagram
SwitchA
SwitchB
Ethernet1/1
vlan1
Ethernet1/1
vlan1
Ethernet1/2
vlan2