PLANET XGS3-24040 - Manual (Page 432)

Chapter 44 IPv6 Multicast Protocol
44-30
no ipv6 mld snooping vlan
immediate-leave
this command cancels the immediate leave
configuration.
ipv6 mld snooping vlan <vlan-id> query-mrsp
<value>
no ipv6 mld snooping vlan <vlan-id> query-mrsp
Configure the query maximum response period. The
“no” form of this command restores to the default.
ipv6 mld snooping vlan
query-robustness <value>
no ipv6 mld snooping vlan
query-robustness
Configure the query robustness, the “no” form of this
command restores to the default.
ipv6 mld snooping vlan <vlan-id>
suppression-query-time <value>
no ipv6 mld snooping vlan <vlan-id>
suppression-query-time
Configure the suppression query time. The “no” form
of this command restores to the default
Ipv6 mld snooping vlan static-group
[source ] interface
[ethernet | port-channel]
no ipv6 mld snooping vlan
static-group [source ]
interface [ethernet | port-channel]
Configure static-group on specified port of the VLAN.
The no form of the command cancels this
configuration.
44.7.3 MLD Snooping Examples
Scenario 1: MLD Snooping Function
Figure 2-6 Open the switch MLD Snooping Function figure
As shown above, the vlan 100 configured on the switch consists of ports 1, 2, 6, 10, 12. Four hosts are
respectively connected to 2, 6, 10, 12 while the multicast router on port 1. Suppose we need MLD Snooping
on VLAN 100, however by default, the global MLD Snooping as well as the MLD Snooping on each VLAN are,
therefore first we have to enable the global MLD Snooping at the same time enable the MLD Snooping on
VLAN 100, furthermore we need to set the port 1 of VLAN 100 as a mrouter port.
Configuration procedure is as follows.
Multicast Router
Mrouter Port
MLD Snooping
Switch
Group1 Group1 Group1 Group2